WinKFP will give you a message about having X number of flashes available. Press “Done” You will be displayed the vehicle information and the boost section update activated message.Ĭlick “F3: Program”. Click OK.Ĭlick “Enter VIN” and manually enter 17-digit VIN correctly If the voltage is below 12.5V or above 14.5V, the flashing procedure may fail and results in brick the module.Ĭlick “Enter ZUSB”, select ECU type: GDSMG2 and choose ZB-number: 7843255. NOTE: Keep the vehicle voltage at 13-14V. Press “OK” and wait a few minutes to load the data.Ĭlick “Configuration” and do some settings, language, file destination etc, make sure the program configuration setting is the same as picture below:īrowse the unzipped SP-Daten-E46 folder to:Ĭopy the contents of the ecu folder to C:/EDIABAS/EcuĬopy the contents of the sgdat folder to C:/EC-APPS/NFS/SGDAT Select and run WinKFP software on the desktopĬlick Import/Export ->Import ->Assembly Line Dataīrowse to the unzipped SP-Daten-E46 folder and select the “data” folder. Well install BMW ICOM ISTA/D ISTA/P software HDD Stable power supply 13-14V at 10A (very important) Here is an example of coding BMW E46 M3 (with SMG2 transmission) Euro SMG mode also called "CSL Coding" with BMW ICOM engineering and developing WinKFP coding software.īMW ICOM ISTA/D ISTA/P with WinKFP 5.1.6 or newer version software HDD and 46 data filesīMW ICOM A2+B+C diagnostic and programming tool
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |